Wednesday, June 17, 2015

Laser Cut Tree Bookshelf by Kristina J guest post for Trotec Lasers



Inspiration for laser projects can strike anywhere. It hit me when looking over the exceptionally creative DIY site, theDesignConfidential.com, where I came across this tree bookshelf. In the tutorial, they used a paper stencil and jig saw. I knew that this was definitely a project that could not only be done with a laser, but improved. With the author, Rayan Turner’s permission, I took the original plans and turned it into this great laser project, perfect for a child’s room, a school, or a whimsical library.
Step 1: Materials 




17 sheets of ½” plywood, cut into 4’ x 2’ sections. Try to choose the flattest pieces possible.

Wood glue
Finishing nails
Clamps
Large format laser cutter, we used a Trotec SP500 laser with 200 watts of power


Step 2: Design
The tree is cut into thirds to fit the sheets of wood. In order to make it more stable when being glued together, there are 2 sets of drawings – each with the cut shifted 1 inch. The final tree is approximately 6 feet tall and 4 feet wide. If you would like to change the size of the tree to fit your space, make sure that you scale each drawing appropriately.
find vector files prepared for laser cutting on the following link : http://www.instructables.com/id/Laser-Cut-Tree-Bookshelf/ 

Step 3: Laser ! 



We cut the sheets of plywood on a SP500, 200 watt laser. This laser will accommodate materials up to 49” wide and 28” tall. Depending on how warped your sheets of wood are, you may need to tape down the edges to get the best cut. Also, due to the thickness of the wood, you’ll want to focus the laser “into” the wood a little bit. You can do this by setting the Z-Offset. This will help ensure that the cut is straight, and not at an angle.
Laser settings
Trotec SP500, 200 watt laser cut settings
Power: 100%, Speed: 0.6%, Hz: 5000, Z-Offset: -.10”, Correction: 25
Cut four each of the different Top and Middle sections, and cut one of the Bottom section (it has all 8 trunks on the same board).


4 comments:

  1. Great... now I want to upgrade my 400 flexx to 200 watts... too bad it isn't available. I did cut 3/4 inch laminate with my 110W CO2 so technically, this project is still possible to do though a bit slower.

    Jon

    ReplyDelete
    Replies
    1. Dear Jon,

      Thank you for your comment. If you would like to share some of your laser cut work on our blog contact me via mail asekutkovska(@)gmail.com We can arrange a post for you.

      Bests,

      Aleksandra

      Delete
  2. Thank you for following our work !

    ReplyDelete

A dash of Minimal chic: On outfits, exhibitions & invitations - Featuring The Paperless Post

featuring Oscar de la Renta cards design for Paperless post  https://www.paperlesspost.com/cards/group/oscar_de_la_renta Oh, the sme...